The snake moves forward until it reaches the line. When the snake encounters an obstruction, the twisting motion of the end of the stick sticks onto the obstruction so it can be pulled out. The snake then moves on to the next clog, and so on, until all the blocks have been removed. “It’s a very efficient way of removing blocks,” .
Table of Contents
What is the difference between an auger and a snake?
Drain snakes work for smaller drains like your kitchen or bathroom sink. Drain augers tackle larger pipes like your toilet or kitchen faucet.
Do you run water while snaking a drain?
If you didn’t remove the trap, run cold water while you snake. If you push the auger into the drain with a lot of force, you could damage the entrance to the drain. If you don’t have access to a trap door, you can use the same method as above, but this time you’ll need to make sure that you have a way to get out of this trap.
You can either use a ladder or a rope to climb out. The ladder is easier to use than the rope, since it doesn’t take up much space, and it can be used in a variety of different ways.
For example, if you’re using the ladder to reach the top of a building, then you might want to tie a piece of string to the end of it, so that when you climb down, the string will pull you back up. This is also a good way of making sure you won’t fall into a pit or other hazard.
A rope can also be tied around the neck of your snake to prevent it from getting stuck in the grate.
Should I snake my own drain?
For smaller clogs, snaking your own drain is possible. U-shaped trap below the sink or a few feet deeper in the drainpipe are the most common places for minor sink clogs from hairballs or food remnants. They can be cleared by using a light-gauge, hand-operated plunger.
If the clog is deep enough, you may need to use a hand pump to force the water out of the trap. If you have a sink that is not equipped with a trap, the easiest way to clear a clogged drain pipe is to fill it up with water. This will flush out the trapped water and allow you to drain the pipe again.
Can you snake a dry drain?
To snake your own drain, the most important tool you’ll need is, obviously, a drain snake. You might not want to spend the money on a tool if the clog is small. If you find yourself in this situation, you may want to grab a coat hanger from the closet.
You can use a piece of duct tape to hold the drain in place while you work on it. This will allow you to use the sink without having to worry about getting your hands dirty.
What if snaking a drain doesn’t work?
If your snake isn’t clearing your drain, it could be because the thumbscrew is loose, or the auger is dirty. Maybe you need a lesson on how to use a drain snake. A drain auger is a simple, inexpensive necessity for any snake owner.
How long does a drain snake need to be?
The minimum length of the cable should be 75 to 100 feet in length, because they are designed for the toughest of clogs. This snake is designed to clean out drains that are 3 inches or larger, which typically includes clean outs to sewer, storm drain, and septic systems.
How do you snake an outside drain?
If you want to snake a drain from outside, start with a long manual or powered drain auger. Take care not to get any water into the house by feeding the head of the snake and connecting the cable through the cleanout drain outside. If you are using a hand pump, make sure that the pump is set to the lowest setting.
If you have a garden hose, you may want to use the hose to drain the water from the outside of your house. You can also use a bucket of water to fill the bucket with water and then fill it back up with fresh water.
